A "Little Special" Screw-bit Driver
for those tight spots
Why you may find these screw drivers very useful...
Easier access to very tight spaces where a low torque screw needs to be serviced by hand, such as the initial intent of throat plate removal on sewing machines
Magnet in each driver holds bits in place and holds onto steel screws while allowing for simple changing of bits
Works with any standard 1/4" hex drive screw bits (1" long typical for most compact)
Will also work with 1/4" hex drive nut driver or other type of bits
Red winged driver for easier breaking loose or finish tightening
Blue minimal barrel driver for extra tight space removal or insertion of screw, because some of us can't get our fingers to spin those screws without a little help
Divit in the rear of driver helps keep the driver seated on finger tip
Recesses in the outside of the barrel and wing help keep the driver within the grip of fingertips
Knurl like pattern for increased grip
Any screw bits supplied with the drivers are MADE IN THE USA.
The plastic is 3D printed from 100% post industrial recycled material.
The plastic packaging/storage container is made in USA.
The internal rare earth magnets are from China (please send me a message if you know of a USA manufacturer).
WARNING : While the tool steel screw bits are able to achieve high forces when used in metal constructed drivers, these little special screw-bit holders are for low torque applications. Using excessive force will damage the plastic drivers and possibly injure your hand in extreme situations where common sense is ignored. Use them appropriately and safely and everyone gets home in one piece.